gc
toe_in_pin_config
toein
Trendsetter_NEWS
This parameter indicates whether the toe-in pin configuration is used on this machine.
To properly support wide 44" plates, the registration pins for those machines have been changed
slightly so that the two outside pins are higher than the two inside pins. This configuration is
called "toe-in" because broadsheet plates will be rotated towards each other.
This change was implemented on ECO #202, and is recorded by 100 label #6.
If this parmeter is set to 1, the toe-in configuration is used, and the firmware expects large plates
to sit on pins 1 and 4 (numbered starting with 1 at the home side), and to be centered in the machine.
Plates smaller than 800mm (about 31.5") will sit on pins 1 and 3.
If this parameter is set to 0, the old-style configuration is used, and the firmware expects all plates
larger than 450mm to sit on pins 1 and 3, and to be off-centre in the machine.
byte
1
0 to 1
This parameter is only present in TS News firmware versions 1.12 and above.
cfg